The Custom LED "Blinker Genie" is designed to allow single filament light bulbs, single intensity LED assemblies, or any two-wire indicators to function as both running lights AND blinkers - at full brightness!
Simply connect your two-wire incandescent or LED indicators to the Custom LED Blinker Genie, and your indicator bulbs/LEDs will now stay on constantly as running lights, and blink when you engage the blinkers!
- Allows for Run AND Turn operation of Single-Intensity (2-Wire) LED Blinkers.
-
Formerly called Magic Blinker.
- New high-speed solid state design is compatible with all flasher relays.
- Built-in Stage I Load Equalizer helps prevent the no-blink or 4-way blink condition.
- Comes as a complete kit with electrical connectors and detailed instructions.
- Recommended accessories: Electronic LED Flasher Relay & Posi-Taps
- High-Power capability of 12A/ 180 Watts (2A/ 30 Watts recommended).
- Low on-state resistance means your indicators will be as bright as possible.
- Works with LED or incandescent indicators.
- Made in the USA.
-
Sold as a PAIR.
(Note: the indicator will turn off for the duration of the blinker pulse - this is how the blinking is achieved.)
The Custom LED Blinker Genie is designed to be as small as possible while being as versatile and robust as possible. The finished dimensions of the unit will measure less than 0.7" x 1.25" X 0.25" and can carry up to 12A of current (see specifications)! This ensures this product will work for any application (blinking your headlights individually, or powering one single LED signal for instance).
To further ease installation and ensure dependability, the Custom LED Blinker Genies are entirely water resistant.
The Blinker Genie is applicable for any and all situations where a single filament lamp, or single brightness LED or LED cluster is desired to function as both a running light and a blinker light.
One Blinker Genie controls up to 2A worth of indicators on a single blinker circuit in the recommended configuration. The Blinker Genies are sold IN PAIRS. One will be required for each side of the motorcycle, for every 2A worth of switched indicator load (25W).
For most applications, they are used in the front to drive two wire LED indicators. Technically, if you ran wires to the back, you could control the rear indicators with the Blinker Genies as well. However, it is recommend that you use one Blinker Genie for each "corner" of the vehicle/motorcycle.
The Blinker Genies come with 7" leads, all required electrical connectors and detailed installation instructions!
-
Made in the USA!
-
New high-speed solid state design is compatible with all flasher relays.
-
Built-in Stage I Load Equalizer helps prevent the no-blink or 4-way blink condition.
-
Comes as a complete kit with electrical connectors and detailed instructions.
-
OEM turn signal connectors available for a plug and play install (sold separately).
-
High-Power capability of 12A/ 180 Watts (2A/ 30 Watts recommended).
-
Low on-state resistance means your indicators will be as bright as possible!
-
Works with LED or incandescent indicators.
Electrical Specifications:
-
Maximum Recommended Indicator Load: 2A (30W)
-
Maximum Switching Current: 12A
-
Internal Resistance: 0.18 OHMS
-
Maximum Switching Speed: 1Mhz
-
Switch type: Advanced Power Mosfet
-
ONLY functions with a Negative Ground System (most common)