Égaliseur de charge de l'étage 2

The Custom LED 25-Watt Load Equalizer (formerly known as the Stage II Load Equalizer) may be for you if your OEM turn signal lamps are 20 to 30 Watts each, and the following matches your situation after changing them:

• the blinkers work but blink faster than stock
• the blinkers do not blink at all - either they turn on and stay on solid or they don't even come on at all
• the left and right directional signals illuminate at the same time when activated (4-way blink problem)

CLED's 25-Watt Load Equalizer is basically a 25 Watt power sink that will make the OEM flasher relay think your stock turn signal bulbs are still there!  This means, if you install our 25-Watt Load Equalizer in each blinker location that there was a 20 to 30 Watt OEM incandescent turn signal lamp - that has been replaced by an LED lamp - your blinkers will blink normally.

CLED 25-Watt Load Equalizer is enclosed in a water tight housing that can be mounted anywhere on the bike. 

This Load Equalizer couldn't be easier to install!  The device is small and connects to the turn signal wires only.  Your order will come with detailed instructions and simple tap connectors that do not require any cutting of the factory wiring!

These Load Equalizers are over-designed and over-sized for excellent heat capacity.  They will not get too hot under normal operation.  You wont have any overheating problems with our products!

In general, you will need one Load Equalizer for each stock blinker bulb you removed or replaced with LEDs or smaller incandescent bulbs. You will need one Load Equalizer for each side, therefore orders are automatically placed in pairs.